Indoor use: Use only with Raid Automatic Advanced Multi-Insect Control System dispenser. Quality of performance is only guaranteed with Raid Automatic Advanced refills.
Read the instructions thoroughly before installing.
Choose a location where the air circulates freely and where insects are likely to be. Air changes, building layout, temperature and humidity may affect unit's efficiency.
1. Confirm that dispenser is "off" by sliding switch to either "0" position.
2. Connect battery to terminal. Place battery into compartment.
3. Shake can well and then remove protective over- cap from can.
4. Place the dispenser on the Raid can.
5. Push down and twist the dispenser slightly until it stops and locks to the Raid can.
6. Lower the Raid can into the holder and press firmly to attach.
7. Hang product on wall or place on a horizontal surface, preferably 2 meters above floor and at least 30cm below ceiling.
To activate, ensure nozzle is pointing outwards and away from you. Switch to either "12" or "24" position. The dispenser will activate 10 seconds after switching to the ON position. Your Raid Automatic Advanced Multi-Insect Control System now operates automatically releasing a spray every 7 minutes.
Suitable For: Mosquitoes, flies, cockroaches, and ants
Storage Instructions: Pressurised Dispenser. Protect from sunlight and do not expose to temperature exceeding 50°C. Do not pierce or burn, even after use. Do not store near flame, in vehicles or near any source of heat. Aerosols should be completely empty before dispose a thoughtfully. Recycle empty can if a facility is available or place used can in household rubbish.
